Iris 402 Manuel d'utilisateur télécharger pdf (Page 38)

Restore to Default Settings :

In certain situations whereby the camera ‘locks up’ or fails to respond to communications / commands etc it

may be necessary to carry out a system reset, restoring the cameras configuration to it’s factory settings.

This is achieved by using the Reset button.

Due to the water-resistance design, the Reset button is located inside the housing. To press the Reset

button, it is necessary to open the rear cover. To learn the procedures, please refer to the previous “Install a

Micro- SD card” section.

1. Restart / Reboot the device

Press and release the Reset Button. Within 1 second, the system will be restarted (the LED Indicator will

be steady amber). Upon successful reboot, the LED will be steady green during normal operation.

2. Reset User Management

Press and hold the Reset Button until (around 5 seconds) the LED Indicator flashes green. User

management settings will be reset to default (the LED keeps amber during the process). Upon successful

restore, the LED will be steady green during normal operation.

3. Reset to factory default settings

Press and hold the Reset Button until (over 10 seconds) the LED Indicator becomes red. The system will

start to process restoring settings (the LED keeps amber during the process). Upon successful restore, the

LED will be steady green during normal operation.

LED Indicators :

RJ45 LED’s (Standard ‘Non Waterproof‘ Models Only:

Power & System Status LED’s:

1 2 ... 33 34 35 36 37 38 39 40

Pas de commentaire

Iris 402 Manuel d'utilisateur Page 38